Trusted Home Services in Dodge Center, MN

Completed scheduled air conditioning tune-up on Lennox outdoor condensing unit. Performed comprehensive preventive maintenance including system inspection, cleaning, and operational testing to ensure optimal performance for the cooling season.

Responded to service call for multiple plumbing issues including non-functional garbage disposal, shower drain obstruction with diverter malfunction, and inoperative water softener system. Conducted diagnostic assessment of kitchen disposal unit and under-sink plumbing configuration, evaluated bathroom shower drainage system and diverter valve operation, and inspected water treatment softener equipment. Provided detailed estimates for repair or replacement of all three systems based on findings from visual inspection and operational testing.

Responded to no cooling complaint on residential air conditioning system. Upon arrival, diagnosed restricted airflow due to dirty air filter. Replaced filter and performed complete system maintenance to restore proper operation and cooling performance.

Responded to no cooling complaint and discovered thermostat was set to heating mode instead of cooling mode. Corrected thermostat settings to cooling operation and performed routine maintenance on the system. Unit restored to proper cooling function with no further issues identified.

Responded to service call for tankless water heater displaying error code and providing intermittent hot water to the home. Upon inspection, diagnosed heavily scaled and corroded heat exchanger due to mineral buildup from unfiltered well water supply. Identified absence of iron filter on well water line as contributing factor to accelerated corrosion and scale accumulation. Advised homeowner of need for descaling procedure and recommended installation of iron filtration system to prevent future buildup and extend equipment lifespan.

# HVAC Service - Geothermal Responded to service call for geothermal heat pump system with no heating or cooling capability. Upon arrival, customer had switched to secondary heat source due to system failure. Diagnostic testing identified failed capacitor on geothermal unit as root cause of system malfunction. Removed defective capacitor and installed replacement component. Verified proper system operation and restored geothermal heating and cooling functionality.

Responded to service call for loud noise complaint on residential AC system. Upon arrival, confirmed unit was maintaining cooling capacity despite audible noise issue. Conducted diagnostic inspection of outdoor condenser unit and surrounding components. Identified source of noise as harmonic vibrations occurring in the refrigerant line set. Documented equipment condition and installation with photographs showing condenser unit positioned on concrete pad with adequate clearance from landscaping. Provided customer with detailed estimate for necessary repairs to eliminate vibration issue and restore quiet operation.

Completed comprehensive duct cleaning service including removal of accumulated dust and debris from HVAC ductwork system. Thoroughly cleaned all supply and return vents throughout the property, and performed dryer vent cleaning to ensure proper airflow and reduce fire hazard risk. Documented interior duct conditions with photos showing metal ductwork and flexible connections prior to service completion.

Responded to no heat call on residential furnace system. Upon diagnosis, identified failed control board and transformer as the source of the heating failure. Replaced both the defective control board and transformer under existing parts warranty, restoring full heating operation to the unit.

Responded to service call for non-functioning Morton water softener system. Upon inspection, diagnosed control board failure preventing unit operation. Provided customer with replacement estimate and documented equipment condition with photographs.

Responded to a leaking outdoor hose bibb that had burst and was causing water intrusion into the home. Created ceiling access to reach the failed fixture, removed the damaged hose bibb, and installed a new replacement unit. Restored water service to the property and verified all systems were functioning properly with no leaks present.

Responded to service call regarding thermostat without AC option selection. Upon arrival, performed comprehensive AC preventive maintenance inspection on attic-mounted air handler unit. Verified all system components operational, including blower motor assembly, electrical connections, and condensate drainage lines. Determined AC system functioning properly with no deficiencies found; thermostat issue resolved through user instruction or reprogramming.

Responded to no heat call and diagnosed failed heat exchanger causing dangerous rollout condition. Due to safety hazard and extent of damage, recommended and completed full furnace replacement to restore heating system operation.

Responded to emergency call for outdoor water spigot leaking into basement through ceiling. Upon arrival, determined the outdoor faucet had completely burst, causing active water intrusion into the basement interior. Shut off water supply to the home and removed the failed outdoor faucet assembly. Installed new outdoor faucet with proper freeze-proof specifications. Made secure PEX connection in basement ceiling to supply line, ensuring proper support and protection of piping. Restored water service to home and tested all connections for leaks. Verified outdoor faucet operation and confirmed no further water intrusion into basement. All systems functioning properly upon completion.

Successfully installed outdoor temperature sensor in the geothermal system as per the sold bid specifications. Routed and secured sensor wiring through the structural space, properly labeled connections for future service identification.

Responded to service call for bathroom exhaust fan repeatedly tripping circuit breaker during customer's installation attempt. Diagnostic inspection revealed pinched and broken wiring in ceiling cavity. Repaired issue by replacing damaged section with new wire and installed proper switch leg connection to restore safe operation of the bathroom fan.

Responded to callback for furnace failure after previous service on 2/17. Upon inspection, identified clogged condensate trap as the root cause of system shutdown. Successfully cleared the obstruction in the trap, restoring proper condensate drainage and returning the furnace to normal operation.

Successfully removed existing Moen kitchen faucet and installed customer-supplied replacement Moen model with side sprayer. Completed all necessary connections and performed functionality test with positive results - all components operating properly with no leaks observed.

Performed scheduled preventative maintenance agreement service on residential HVAC system. Accessed and inspected furnace components, completed standard tune-up procedures including filter replacement. No issues identified during service; system operating normally upon completion.

Performed scheduled preventative maintenance agreement service on air handler. Arrived within scheduled window (8-12). Conducted comprehensive system tune-up with no issues identified. Inspected and documented plumbing components including PVC pipes with proper cement application and flexible supply lines with brass fittings. System operating within normal parameters after service.

Responded to zone heating issue where basement register was drawing excessive heat from addition vent. Diagnosed airflow imbalance between zones with thermostat reading 74°F despite 68°F setpoint. Recommended closing basement vent or installing booster fan to correct distribution problem. Replaced air filter with new pleated filter during service.

Responded to no heat complaint for LP furnace over 10 years old. Diagnosed tripped rollout switch due to excessive debris on burners. Service included removing burner assembly, performing thorough cleaning to restore proper flame pattern and combustion, then verifying safe operation after reassembly.

Performed scheduled generator maintenance inspection with arrival between 8-12. Documented equipment information including POWERZONE control panel functionality and air filtration system. Provided information to management for maintenance kit quote preparation as required for service agreement completion.

Responded to service call for leaking Moen kitchen faucet. Upon inspection, determined that manufacturer had sent incorrect replacement parts. Advised customer to contact Moen for correct components and schedule follow-up appointment for faucet installation once new parts are delivered.

Responded to service call for geothermal unit with intermittent compressor operation and water leak. Diagnostic inspection revealed system shutting down after brief operation. Heat currently being provided by backup furnace. Inspected HBX ECO-0550 Control Processing Unit and internal electrical components, and noted need for temperature/pressure gauge replacement.