Your Trusted Home Services Team in Rochester, MN

Responded to no hot water complaint and confirmed existing tanked water heater had failed and was no longer producing hot water. Performed on-site assessment of the unit and surrounding plumbing configuration in basement utility area. Provided estimate for replacement with new 40-gallon atmospheric vent natural gas water heater, including all necessary connections and venting components.

Completed scheduled preventive maintenance agreement tune-up on Lennox air handler system. Performed comprehensive system diagnostics using digital testing equipment to verify operational parameters and system performance. All components inspected and found operating within normal specifications with no deficiencies noted requiring correction at this time.

Completed installation of customer-provided generator transfer switch in residential basement utility area. Installed EZ switch with proper electrical connections to existing main service panel, ensuring code-compliant wiring and secure mounting to wooden wall structure. All circuit connections verified, panel labeled appropriately, and system tested for proper operation between utility and generator power sources.

Completed return appointment to wire and install two outlets in newly framed basement wall. Electrical wiring had been properly run by framing crew through stud cavities with foam insulation panels installed. Landed all wires in outlet boxes, terminated connections, and installed receptacles into boxes to complete the electrical installation.

Conducted electrical safety assessment of century-old residential property requiring comprehensive GFCI outlet and wiring upgrades throughout the home. Inspected existing electrical panel and identified complete absence of arc fault circuit interrupter (AFCI) protection on all branch circuits. Provided detailed estimate for whole-home surge protection system installation and recommended specific breakers requiring conversion to AFCI protection per current electrical code requirements. Documented existing panel configuration, ceiling cavity wiring conditions, and structural access points for future upgrade implementation.

Completed comprehensive one-time tune-up service on residential furnace and air conditioning system. Performed standard maintenance procedures including inspection of all mechanical and electrical components, blower motor assembly, belt tension verification, and venting system check. System found to be operating within normal parameters with no issues identified requiring repair or adjustment.

Responded to no cooling call on Lennox air conditioning system. Upon inspection, diagnosed weak capacitor and confirmed system low on refrigerant charge. Provided customer with estimates for capacitor replacement and refrigerant leak search with repair to restore proper system operation.

Installed replacement rectifier and relay components in HVAC system. Completed thorough testing of unit operation in both heating and cooling modes to verify proper functionality. Left system operating in heating mode at 65° setpoint.

Responded to no heat call on Amana furnace following LP tank run-out. Upon inspection, discovered unit was operating on propane but lacked required LP shut-off safety kit and proper gas valve conversion components. Ordered and will install LP shut-off kit and gas valve conversion kit to bring system into compliance with propane fuel requirements and safety standards.

Responded to no cooling complaint on 9-year-old AC system. Diagnosed low voltage short in thermostat wire between outdoor unit termination and indoor equipment. Replaced damaged two-wire control circuit to restore proper system operation and cooling functionality.

Responded to kitchen sink drainage issue where water was backing up during use. Upon inspection, identified severe grease accumulation in the kitchen drain line causing the blockage. Determined that hydro jetting would be required to effectively clear the heavy grease buildup. Coordinated with Rochester Drain Rite for hydro jet service to restore proper drainage function.

Replaced defective pressure switch under warranty on furnace system. Performed carbon monoxide testing to verify safe operation and inspected exhaust and intake venting to ensure proper airflow with no obstructions present.

Responded to service call for water discoloration and brown spots appearing on laundry, with additional complaints of foul odor from hot water throughout the home. Upon inspection, diagnosed the issue as a failed anode rod in the AO Smith ProLine water heater. Removed the deteriorated anode rod and installed a new replacement rod to restore water quality and eliminate odor issues.

Responded to service call for previously diagnosed refrigerant leak on Lennox air conditioning system. Located failed braze joint on copper refrigerant line that had been identified during initial diagnostic visit. Performed proper brazing repair to seal the leak point on the refrigerant piping. After completing the repair and conducting leak check to verify integrity of the brazed connection, recharged the system to manufacturer specifications and confirmed proper operation of the unit.

Responded to service call for non-functioning outdoor post lights that were tripping GFCI protection, potentially related to recent driveway remodeling work. Troubleshot the circuit and identified a break in the underground wire feeding the post lights. Inspected electrical panels and affected wiring, documented conditions with photographs, and provided estimate for wire repair to restore proper operation of the outdoor lighting system.

Responded to service call for leaking toilet and lavatory faucet in upstairs hallway bathroom. Upon inspection, identified failed fill valve and handle assembly in toilet tank, along with severely corroded lavatory faucet requiring full replacement. Removed and replaced defective toilet fill valve and flush handle with new components. Removed corroded lavatory faucet and installed new single-handle Moen faucet assembly. Tested all fixtures for proper operation and verified no leaks present. All repairs completed successfully with fixtures functioning as designed.

Responded to service call for AC system running with unusual noises and burning odor. Upon inspection, diagnosed failing blower motor, defective capacitor, and contaminated blower wheel. Borescope inspection revealed compromised secondary heat exchanger, presenting a safety hazard. Red-tagged furnace due to heat exchanger failure and provided customer with repair options and replacement quote.

Responded to no-power call for kitchen outlet serving garbage disposal. Upon inspection, determined that homeowner had recently installed new disposal outlet but failed to activate the corresponding wall switch. Verified electrical connections were properly made and confirmed power restoration once switch was turned on. Advised homeowner on proper operation of switched outlet for garbage disposal unit.

Responded to service call for dining room lighting modification. Removed two existing light fixtures and associated electrical boxes. Installed remodeler box between ceiling rafters to accommodate new single chandelier location. Completed electrical connections and mounted new chandelier fixture per manufacturer specifications. Verified proper operation and cleaned work area upon completion.

Provided estimates for installation of four recessed can lights in kitchen and replacement of two bathroom exhaust fans. Assessed existing electrical circuits and ceiling access requirements to determine scope of work and material specifications for the requested lighting and ventilation upgrades.