Your Trusted Home Services Team in Rochester, MN

Responded to no-power call for residential furnace system. Upon arrival, confirmed complete loss of power to TempStar furnace unit. Performed electrical inspection of furnace control panel and associated electrical components mounted on wooden framing near HVAC installation. Identified electrical supply issue requiring specialist intervention and coordinated electrician dispatch to address power distribution problem affecting furnace operation.

Completed preventive maintenance agreement service on residential Lennox condensing unit. Performed comprehensive system inspection, cleaned condenser coils, checked refrigerant levels, tested electrical connections, and verified proper operation of all components to ensure optimal performance for the cooling season.

Responded to service call for non-functioning water conditioning system. Upon arrival, performed diagnostic testing on existing two-piece water softener unit (2005 model) and confirmed system failure. Inspected brine tank salt levels and control valve assembly. After thorough evaluation, determined unit was beyond economical repair due to age and component failure. Provided customer with estimate for replacement water softener system.

Completed comprehensive preventive maintenance agreement service on both furnace and air conditioning system. Performed full inspection of Lennox air handler unit located in attic space, including examination of electrical connections, control wiring, and refrigerant lines. Conducted outdoor condensing unit maintenance with detailed inspection of electrical control panel, contactor operation, and all internal wiring connections. Verified proper operation of all system components, checked condensate drain line functionality, and ensured all safety controls were operating within manufacturer specifications. System tested and left in proper working condition.

Responded to a toilet malfunction in the upstairs hallway bathroom where the fixture was not filling or flushing properly due to low water pressure. Diagnosed a faulty fill valve as the root cause, removed the defective component, and installed a new fill valve. Tested the toilet to confirm proper filling and flushing operation, with all functions restored to normal working condition.

Responded to service call for garbage disposal air switch that was difficult to operate. Upon inspection, determined the air switch was faulty with a visible crack in the air line, preventing proper activation of the disposal unit. Removed the defective air switch assembly and installed a new replacement unit. Tested the system to verify proper operation and functionality of the garbage disposal.

Completed preventive maintenance agreement service on residential air conditioning system. Performed comprehensive inspection and routine maintenance procedures on outdoor condenser unit, including cleaning, testing electrical components, and verifying proper system operation per manufacturer specifications.

Completed preventive maintenance agreement tune-up on residential outdoor air conditioning condenser unit. Performed comprehensive system inspection and standard maintenance procedures per agreement terms, with all components found operating within normal parameters and no deficiencies identified requiring correction.

Completed preventive maintenance agreement service on residential heating and air conditioning system. Performed comprehensive tune-up on furnace unit in basement, inspecting internal components, wiring, circuit boards, and mechanical assemblies with front panel access. Conducted full preventive maintenance on outdoor Lennox condensing unit, inspecting condenser coil, fan assembly, and electrical connections. All systems operating within normal parameters with no deficiencies found. Equipment tuned and returned to service.

Responded to service call for ceiling fan replacement evaluation. Assessed existing ceiling fan fixtures in residential property and provided detailed estimates for removal and replacement of units. Customer opted to review estimates before proceeding with installation work.

Responded to service call for reported high-pitched squeaking noise from furnace unit. Upon arrival, conducted thorough inspection of furnace and associated mechanical components but was unable to recreate the reported noise during diagnostic testing. Advised that technician will return if issue persists for further evaluation.

Conducted on-site evaluation of existing 40-gallon AO Smith ProMax atmospheric vent water heater located in basement. Prepared and provided estimate for replacement with 40-gallon power vent water heater, including installation of new vent and exhaust system routed from basement through exterior wall of home.

Responded to service call for reported water under carpet and flooring in bathroom. Upon arrival, conducted thorough inspection of bathroom area including vanity, toilet, tub/shower combination, and surrounding flooring. Examined wood-look laminate flooring for moisture damage and investigated potential leak sources. Assessed plumbing fixtures including dual sink vanity with chrome faucets, toilet, and tub/shower plumbing for visible leaks or water intrusion. Determined wet carpet condition was result of ground water infiltration rather than plumbing system failure. No active leaks detected from supply lines, drain lines, or fixture connections. Documented conditions with photographs for service records.

Responded to no heat call and arrived on site to find heating system inoperative. Upon investigation, discovered that the light switch controlling power to the furnace had been inadvertently turned off. Restored power by turning on the light switch and cycled the system through complete operation to verify proper function. Unit fired successfully with pilot light igniting and burners operating normally. Confirmed adequate heat output and normal system operation before departure.

Responded to service call for upstairs hallway shower delivering only hot water and laundry room faucet producing hammering noise when turned on fully. Diagnosed faulty Moen 1222 cartridge in upstairs hallway bathroom shower valve preventing cold water flow. Removed defective cartridge and installed new replacement cartridge, restoring proper hot and cold water mixing function to shower. Investigated laundry room faucet water hammering issue and determined cold water supply angle stop valves were not fully open, restricting water flow and causing pressure surge noise. Opened angle stop valves completely, eliminating water hammering sound. All fixtures tested and confirmed operating properly upon completion.

Responded to service call for circuit breaker repeatedly tripping in residential electrical panel. Upon arrival and inspection, diagnosed faulty breaker as the source of the problem. Removed defective breaker and installed new replacement breaker to restore proper circuit protection and functionality.

Responded to service call for clogged kitchen drain. Upon arrival, assessed the drainage issue and inspected the garbage disposal unit. Provided estimates for garbage disposal replacement, water heater replacement, and iron filtration system installation based on customer inquiry. Performed water quality testing which revealed elevated iron levels, documented existing plumbing infrastructure including copper supply lines, PVC drain lines, and mechanical systems in basement utility area.

Completed scheduled preventive maintenance agreement inspection on residential air conditioning system. Unit operational with all components functioning within normal parameters. Performed standard maintenance procedures including visual inspection of condenser unit, refrigerant lines, electrical connections, and disconnect box. No deficiencies identified during inspection. System cleared for continued operation.

Completed scheduled air conditioning preventive maintenance on residential HVAC system. Diagnosed and replaced two failed capacitors on outdoor condenser unit to restore proper system operation. Installed new air filters as part of routine maintenance service. System tested and confirmed operating within normal parameters following repairs.

Responded to loss of power issue affecting garage door, hallway light, and multiple outlets that were tripping breaker. Upon investigation, diagnosed missing hot leg at electrical service entrance from meter. Coordinated with RPU to address utility-side power supply deficiency. Documented electrical meter and service panel configuration with photos showing exterior mounted components, conduit system, and service entrance equipment.