Your Trusted Home Services Team in Rochester, MN

Completed scheduled preventative maintenance on residential Bryant air conditioning system. Performed comprehensive inspection of outdoor condenser unit, verified proper operation of all components, and documented equipment condition with photos. Unit found to be in good working order with no immediate repairs required at time of service.

Responded to emergency call for pinhole leak in residential copper water line. Located leak on 1/2" copper water main immediately downstream of the water meter. Shut off water supply and removed damaged section of pipe and compromised fitting. Installed new copper pipe and fittings to code specifications. Restored water service to the residence and verified all plumbing systems were functioning properly with no additional leaks detected.

Completed preventive maintenance agreement service on residential air conditioning system. Performed comprehensive inspection of outdoor condenser unit, verified proper operation of all components including fan motor and compressor, and replaced indoor air filter with new pleated media filter to ensure optimal system airflow and efficiency.

Responded to service call for furnace switch wiring issue. Upon arrival, found damaged wiring at furnace switch location that required immediate attention for safe operation. Properly taped and secured exposed wires, reconnected all electrical connections to code specifications, and reinstalled the furnace switch. Verified proper operation of electrical panel and circuit breakers serving the furnace circuit, ensuring all connections were secure and safely terminated.

Responded to service call for leaking water heater. Upon arrival, confirmed active leak from tank requiring full unit replacement. Removed existing failed water heater and installed new A.O. Smith ProMax tanked water heater. Connected copper water supply lines, installed new flexible gas line with shut-off valve, and properly vented unit with metallic flue pipe. Tested all connections for leaks, verified proper gas flow and combustion, and ensured system operational before departure.

Completed scheduled preventive maintenance on residential air conditioning system. Performed comprehensive tune-up including inspection of condenser unit, verification of operational parameters, and system optimization. Unit found operating within normal specifications with no deficiencies noted.

Responded to no hot water complaint and diagnosed 50-gallon atmospheric vent water heater with failed burner assembly due to corrosion, rendering unit inoperable. Inspected gas combustion system and determined burner assembly deterioration prevented proper ignition and operation. Presented repair versus replacement options, and customer elected full water heater replacement. Scheduled return visit with two-person crew to complete water heater changeout and ensure proper installation of new unit.

Responded to service call for non-functioning electrical outlets and Ethernet ports throughout the residence. Diagnosed faulty circuit breaker that would not reset properly. Removed defective breaker from electrical panel and installed new replacement breaker to restore power to affected circuits.

Completed comprehensive duct cleaning service for residential HVAC system. Removed accumulated dust, debris, lint, and fibrous material from ductwork and ventilation components, including thorough cleaning of all accessible vents and registers. System components inspected and documented, with significant buildup noted on mechanical fittings and duct surfaces prior to cleaning.

Completed one-time air conditioning tune-up on residential outdoor condensing unit. Performed standard preventive maintenance inspection, verified proper system operation, and confirmed all components functioning within normal parameters. Unit operating efficiently with no issues identified.

Responded to kitchen faucet continuously dripping due to failed cartridge and deteriorated o-rings. Removed old Moen single-lever faucet and installed new Moen kitchen faucet with side sprayer. Inspected washer hookups for reported leaks and addressed accessible plumbing concerns during the service call.

Completed preventive maintenance agreement inspection on Lennox air conditioning system. During routine testing, identified failed capacitor with degraded capacitance reading of 46.17 µF on C65A 440VAC rated component. Replaced defective capacitor with new unit to restore proper compressor and fan motor operation, ensuring system reliability and preventing potential equipment failure.

Responded to service call for Square D circuit breaker that would not reset following storm activity. Diagnosed breaker tripping issue and identified direct short in one of the existing outlets on the circuit. Replaced three defective outlets and installed weatherproof outdoor covers on exterior receptacles to provide proper protection from the elements.

Responded to no cooling complaint on residential air conditioning system. Upon arrival, confirmed outdoor fan motor operating but indoor blower not running. Diagnosed failed dual run capacitor causing indoor blower failure. Replaced defective capacitor with new TITAN HD unit, restored system operation, and verified proper cooling performance by measuring supply and return air temperature differential.

Completed preventive maintenance agreement inspection on residential air conditioning system. Upon arrival, performed comprehensive evaluation of outdoor condenser unit and indoor cassette-style air handler. During inspection, discovered excessive dust accumulation in return ductwork and recommended professional ductwork cleaning to improve system efficiency and indoor air quality. Documented equipment condition with photos showing outdoor unit positioned on concrete pad with debris accumulation around base and indoor ceiling-mounted unit. All routine maintenance tasks completed per agreement specifications.

Responded to urgent service call to inspect a sealed vent on exterior wall during active siding installation. Upon arrival, identified the opening as a fresh air intake vent that had been covered by new building wrap material. Evaluated the system and determined the fresh air intake should remain accessible and operational, advising the customer accordingly before departing the site.

Arrived on-site to assess existing tanked water heater installation and provide estimate for replacement. Conducted thorough inspection of current unit, including evaluation of copper supply piping, metallic venting system, and connection points. Documented existing equipment specifications and installation conditions through photographic documentation for estimate preparation purposes.

Responded to service call for toilet leaking at the wax ring and two faucets with difficult shutoff operation. Successfully removed and replaced defective wax ring seal at toilet base, resolving the leak issue. Inspected both faucets for worn compression washers as requested.

Responded to a basement floor drain backup caused by a blockage in the mainline drain system. Upon inspection, confirmed that the mainline stoppage was causing sewage to back up through the basement floor drain. Advised the customer to contact a specialized drain cleaning service for mainline clearance, as the blockage required equipment and expertise beyond standard plumbing service capabilities.

Responded to emergency call for shower valve malfunction with water continuously running and unable to shut off. Upon arrival, diagnosed faulty shower cartridge causing loss of water control. Successfully removed and replaced defective cartridge in single-handle shower control valve, restoring proper shut-off function and eliminating continuous water flow.