Your Trusted Home Services Team in Rochester, MN

Responded to no hot water complaint and diagnosed water heater failure to ignite. Identified defective flammable vapor sensor preventing gas valve operation. Removed faulty sensor from Honeywell gas control valve and installed replacement sensor. Performed factory reset procedure on gas control valve, successfully ignited pilot light, and verified proper burner operation and hot water production.

Completed comprehensive electrical wiring installation across multiple scheduled appointments at commercial property. All rough-in and finish wiring work was performed according to specifications, with coordination calls made prior to each arrival to ensure property access and minimize disruption to operations.

Responded to no cooling complaint on residential air conditioning system installed five months prior. Upon inspection, identified refrigerant leak at press fitting connection on service valve. Replaced defective service valve to restore system integrity and proper cooling operation.

Responded to callback for persistent toilet leak in residential bathroom. Upon arrival, inspected toilet and confirmed active leak still present. Additionally replaced bathroom sink pop-up assembly and associated plunger clip as needed to restore proper drain function.

Performed scheduled preventive maintenance and tune-up on residential air conditioning system. Completed comprehensive inspection of outdoor condensing unit, verified proper operation of all components, and found no issues requiring repair or adjustment.

Removed existing 40-gallon water heater by draining the tank, disconnecting all water and gas connections, and hauling out the old unit. Installed new 50-gallon Bradford White atmospheric vent natural gas water heater in the same location, making all necessary copper piping connections, gas line connections, and venting attachments. Filled the tank, tested all connections for leaks, verified proper gas combustion, and confirmed the unit achieved full operational status with no issues detected.

Responded to no cooling call and diagnosed faulty thermostat as cause of system failure. Collected diagnostic fee and provided estimate to customer for thermostat replacement, pending approval from property management authority before proceeding with repairs.

Responded to no cooling complaint on residential air conditioning system. Upon arrival, performed diagnostic evaluation of outdoor condensing unit and assessed overall system condition. Testing revealed lack of refrigerant in the system. Conducted thorough inspection of unit age, current operational status, and physical condition of components including condenser coils and electrical systems. Based on diagnostic findings, determined that the combination of unit age, existing condition, and cost-effectiveness of repairs warranted recommendation for complete system replacement rather than refrigerant recharge and repair. Documented equipment condition with diagnostic readings and photographic evidence for customer records.

Responded to no cooling complaint on residential air conditioning system. Upon inspection, discovered 24-volt control wire had disconnected from wire nut in electrical compartment. Reconnected and secured wire, restoring proper electrical connection. Performed complete system maintenance and verified unit returned to normal cooling operation.

Responded to no cooling complaint on Carrier air conditioning unit. Upon arrival, confirmed system was running but not providing adequate cooling. Diagnostic testing revealed unit was low on R-22 refrigerant, indicating a leak in the system. Due to the age of the equipment (10+ years) and the phase-out of R-22 refrigerant, recommended scheduling a preventive maintenance visit to provide a comprehensive system evaluation and replacement estimate. Unit requires either leak repair and recharge or full system replacement depending on cost-effectiveness analysis.

Responded to service call for malfunctioning outdoor faucet that would not shut off properly once turned on and exhibited intermittent leaking when in the closed position. Removed existing outdoor spigot at rear of property and installed new anti-siphon frost-proof hose bibb to prevent future freeze damage and ensure proper shut-off functionality. Tested new fixture under full water pressure to confirm complete water flow control and verified no leaks at connection points. Additionally, installed customer-supplied toilet in upstairs hallway bathroom. Removed existing toilet and prepared flange area. Installed new repair flange to ensure proper seal and structural support. Set new toilet using new wax ring seal and secured with new closet bolts. Completed installation per manufacturer specifications and performed multiple flush cycles to verify proper operation, drainage, and seal integrity. All fixtures tested successfully with no leaks detected.

Responded to low water pressure complaint affecting upstairs bathroom. Diagnosed malfunctioning water softener system as root cause of pressure loss throughout home. Replaced defective water softener unit with new system, restored proper water pressure to all fixtures.

Responded to no cooling complaint at mobile home location. Upon arrival, confirmed air conditioning system was completely inoperative. Performed diagnostic evaluation and traced issue to failed circuit breaker in main electrical panel serving the outdoor condensing unit. Breaker would not reset and showed signs of failure. Advised customer that electrical repairs fall outside scope of HVAC service and recommended scheduling licensed electrician to replace defective breaker before system can be restored to operation.

Responded to service call for malfunctioning WaterSoft Legacy View water softener system (Model DS24-3, 24K ISO III). Upon inspection, discovered brine tank was full of water, indicating regeneration cycle failure. Diagnosed control valve malfunction preventing proper brine draw and backwash cycles. Documented system specifications and photographed control head display readings and installation configuration for parts ordering purposes. Customer will obtain replacement parts directly through WaterSoft company, and technician will return for installation upon parts arrival.

Performed comprehensive tune-up on Lennox outdoor condensing unit. Completed standard maintenance protocol including inspection of all major components, cleaning of condenser coil, verification of electrical connections, and refrigerant pressure checks. Unit operating within normal parameters with no deficiencies noted.

Responded to no cooling complaint on aging outdoor condensing unit. Upon arrival, diagnosed failed compressor causing circuit breaker to trip repeatedly. Unit showed significant age-related wear and deterioration. Provided estimate for compressor replacement and discussed repair options with property owner.

Responded to no cooling complaint on outdoor condensing unit located under deck. Upon arrival, system was evaluated and tested. Unable to recreate reported issue as unit powered on normally and cycled properly through all operational phases. System ran without fault during service visit.

Responded to service call for loud fan noise on residential AC unit. Upon inspection, identified loose side panel causing vibration and rattling sounds. Secured panel and discovered unit was low on refrigerant charge. Checked system pressures and confirmed refrigerant leak present. Documented equipment condition with photos showing outdoor condenser unit installation, surrounding components, and overall system layout. Presented customer with repair options including leak detection/repair with refrigerant recharge versus full system replacement based on age and condition of equipment.

Responded to service call for American Standard air conditioning system experiencing loud hammering noise at condenser unit. Upon arrival, observed system cycling on and off intermittently. Diagnostic testing revealed unit was cutting out on low pressure switch and restarting once refrigerant pressure recovered, indicating active refrigerant leak in system. Given the age of the equipment (manufactured 2019) and severity of refrigerant loss, recommended customer consider system replacement versus leak detection and repair with refrigerant recharge. Customer advised of options and associated considerations for each approach.

Responded to no cooling complaint on residential air conditioning system. Upon arrival, discovered main electrical breaker in off position. Reset breaker to restore power to unit and performed complete preventive maintenance service to ensure proper system operation.