Your Trusted Home Services Team in Rochester, MN

Completed preventive maintenance agreement service on residential air conditioning system. Performed comprehensive inspection and maintenance procedures on outdoor condensing unit. Upon completion of all maintenance tasks, verified system operational status and confirmed unit is functioning properly with no issues identified.

Responded to service call for dryer circuit breaker that would not reset and showed signs of moisture infiltration. Upon inspection, determined the breaker had failed and was no longer functional. Removed the defective Square D circuit breaker from the residential electrical panel and installed a new replacement breaker to restore power to the dryer circuit.

Installed GFCI outlet in laundry room to provide ground fault protection for washing machine circuit. Verified proper operation and tested reset functionality to ensure code compliance and safe operation.

Responded to service call for duct cleaning estimate at residential property. Upon arrival, conducted exterior inspection and documented gas meter installation and connections as part of preliminary assessment. Left voicemail message for customer as no answer was received during scheduled appointment window.

Responded to water leak emergency and identified multiple pinhole leaks on main water line and 1/2" copper water line beneath sink area. Successfully repaired all leaks including main line and three additional pinhole failures to restore proper water service and prevent further water damage.

Installed a new 30-amp electrical outlet in garage per customer request. Work included proper wiring from the electrical panel, secure mounting of the receptacle, and verification of correct amperage and grounding for safe operation.

Completed garbage disposal replacement in kitchen under double-basin sink with hardwired electrical connection. Replaced existing disposal unit with new black disposal, ensuring proper mounting and connection to white PVC drain assembly and P-trap configuration. Installation included verifying proper alignment with sink drain opening, securing disposal to mounting ring, and completing straight-wire electrical connection. Provided estimate for potential future work on sink and faucet replacement.

Responded to no heat call on Lennox furnace system that was blowing cold air only. Upon inspection, found air filter in poor condition and diagnosed a failed gas valve preventing proper furnace operation. Replaced gas valve with OEM part and restored heating functionality to the system.

Responded to no heat call and diagnosed complete power loss to furnace system. Inspection revealed electrical supply issue preventing unit operation. Provided temporary space heaters to maintain comfort while coordinating expedited electrical service appointment to restore power to HVAC system.

Responded to water leak call under kitchen sink and diagnosed garbage disposal leaking from bottom of internal tank. Inspected unit and confirmed disposal was failed and leaking from base, requiring replacement. Customer elected to install new disposal unit themselves after receiving diagnostic assessment.

Responded to service call for non-functioning outlets in residential property. Upon inspection, identified GFCI outlet with reversed wiring causing circuit malfunction. Corrected wiring configuration on GFCI receptacle to proper polarity, restoring functionality to affected outlets throughout the circuit.

Responded to service call for four toilets requiring inspection. Diagnosed and identified faulty flush gasket on Kohler mainfloor hallway toilet causing operational issues, and determined slow drainage condition in upstairs hallway bathroom toilet due to suspected blockage. Provided repair assessment and pricing for both units, though customer declined service to attempt self-repair.

Responded to no heat call on residential furnace system over 10 years old. Upon inspection, diagnosed failed control board and collector box rendering the unit inoperable and beyond economical repair. Completed full system replacement to restore heating functionality to the home.

Responded to service call regarding water hammering noise from master bathroom toilet during flushing and previous incident of water shooting from bowl with gurgling sounds during windy conditions. Conducted thorough diagnostic testing by flushing toilet multiple times to attempt replication of reported hammering noise. Unable to duplicate water hammering issue during service visit. Verified toilet is functioning properly with normal flush cycle and no abnormal sounds present at time of inspection.

Responded to service call for non-operational air exchanger system. Upon inspection, found HRV unit not functioning and ventilation grilles heavily soiled with accumulated debris, dust, and organic material. Performed complete HRV maintenance including cleaning of intake and exhaust vents, replaced filters, and restored unit to proper working operation.

Returned to site per inspector's request to install GFCI protection for stove circuit. Successfully installed GFCI breaker in main electrical panel to provide required ground fault protection for kitchen appliance. Documented completed installation with photographs and submitted to inspector for approval.

Returned to property during scheduled 8-12 AM arrival window to remove and haul away 40-gallon residential water heater that had been replaced during previous evening's service call. Unit was successfully disconnected, removed from premises, and properly disposed of per standard protocols.

Responded to service call for leaking tanked water heater in basement utility room. Upon inspection, confirmed active leak originating from bottom of tank, indicating internal tank failure. Documented existing installation including copper supply lines, expansion tank, safety components, and proper venting configuration. Provided comprehensive estimate for complete water heater replacement with new unit, including removal and disposal of failed equipment, installation of new tanked water heater with code-compliant connections, and integration with existing plumbing infrastructure.

Responded to service call for water softener drainage issue in basement utility area. Found softener drain hose improperly positioned on floor with no proper discharge point or sump basin present. Redirected drain hose into existing trapped standpipe in immediate vicinity to provide proper drainage solution. Documented conditions with photos showing water softener system, water heater, floor drain pump, and plumbing configuration. Identified need for future estimate regarding complete bathroom rough-in and installation in basement area, as well as potential sump pump installation with possible customer-supplied equipment.

Responded to service call for toilet that was activating randomly and experiencing tank leakage. Upon inspection, identified incorrect gasket installed on fill valve assembly. Performed minor rebuild of toilet tank components, replacing faulty gasket with proper specification part to ensure correct seal and prevent phantom flushing. Tested system operation to verify repair eliminated random activation and resolved leak issue.