Your Trusted Home Services Team in Rochester, MN

Conducted on-site evaluation of existing 40-gallon AO Smith ProMax atmospheric vent water heater located in basement. Prepared and provided estimate for replacement with 40-gallon power vent water heater, including installation of new vent and exhaust system routed from basement through exterior wall of home.

Responded to service call for reported water under carpet and flooring in bathroom. Upon arrival, conducted thorough inspection of bathroom area including vanity, toilet, tub/shower combination, and surrounding flooring. Examined wood-look laminate flooring for moisture damage and investigated potential leak sources. Assessed plumbing fixtures including dual sink vanity with chrome faucets, toilet, and tub/shower plumbing for visible leaks or water intrusion. Determined wet carpet condition was result of ground water infiltration rather than plumbing system failure. No active leaks detected from supply lines, drain lines, or fixture connections. Documented conditions with photographs for service records.

Responded to no heat call and arrived on site to find heating system inoperative. Upon investigation, discovered that the light switch controlling power to the furnace had been inadvertently turned off. Restored power by turning on the light switch and cycled the system through complete operation to verify proper function. Unit fired successfully with pilot light igniting and burners operating normally. Confirmed adequate heat output and normal system operation before departure.

Responded to service call for upstairs hallway shower delivering only hot water and laundry room faucet producing hammering noise when turned on fully. Diagnosed faulty Moen 1222 cartridge in upstairs hallway bathroom shower valve preventing cold water flow. Removed defective cartridge and installed new replacement cartridge, restoring proper hot and cold water mixing function to shower. Investigated laundry room faucet water hammering issue and determined cold water supply angle stop valves were not fully open, restricting water flow and causing pressure surge noise. Opened angle stop valves completely, eliminating water hammering sound. All fixtures tested and confirmed operating properly upon completion.

Responded to service call for circuit breaker repeatedly tripping in residential electrical panel. Upon arrival and inspection, diagnosed faulty breaker as the source of the problem. Removed defective breaker and installed new replacement breaker to restore proper circuit protection and functionality.

Responded to service call for clogged kitchen drain. Upon arrival, assessed the drainage issue and inspected the garbage disposal unit. Provided estimates for garbage disposal replacement, water heater replacement, and iron filtration system installation based on customer inquiry. Performed water quality testing which revealed elevated iron levels, documented existing plumbing infrastructure including copper supply lines, PVC drain lines, and mechanical systems in basement utility area.

Completed scheduled preventive maintenance agreement inspection on residential air conditioning system. Unit operational with all components functioning within normal parameters. Performed standard maintenance procedures including visual inspection of condenser unit, refrigerant lines, electrical connections, and disconnect box. No deficiencies identified during inspection. System cleared for continued operation.

Completed scheduled air conditioning preventive maintenance on residential HVAC system. Diagnosed and replaced two failed capacitors on outdoor condenser unit to restore proper system operation. Installed new air filters as part of routine maintenance service. System tested and confirmed operating within normal parameters following repairs.

Responded to loss of power issue affecting garage door, hallway light, and multiple outlets that were tripping breaker. Upon investigation, diagnosed missing hot leg at electrical service entrance from meter. Coordinated with RPU to address utility-side power supply deficiency. Documented electrical meter and service panel configuration with photos showing exterior mounted components, conduit system, and service entrance equipment.

Responded to service call for multiple plumbing issues including clogged drains, dishwasher leak, and laundry room sink replacement. Successfully cleared drain line for main floor guest bathroom lavatory faucet, restoring proper drainage function. Provided detailed estimate for complete laundry room sink replacement including new basin, faucet assembly, and drain installation. Documented existing conditions of bathroom sink showing normal wear and utility sink displaying heavy use with accumulated debris. All drain clearing work completed and tested for proper flow.

Conducted on-site inspection of existing recessed lighting system in vaulted ceiling area to assess feasibility for additional fixture installation. Evaluated current electrical infrastructure, switch configuration including dimmer controls, and optimal placement locations for supplemental recessed lighting to enhance illumination throughout the living space. Provided comprehensive estimate for recommended lighting upgrades based on customer requirements and existing electrical capacity.

Responded to service call for non-functioning water softener system. Upon arrival, diagnosed Culligan water softener displaying E2 error code indicating motor failure. Unable to perform repair as Culligan units require manufacturer-specific servicing, so provided customer with replacement estimate for new water treatment system.

Responded to no heat call on residential furnace system. Upon arrival, performed diagnostic testing and identified failed pressure switch preventing unit operation. Removed defective pressure switch and installed replacement component. Verified all electrical connections, tested system operation through complete heating cycle, and confirmed proper ignition sequence and burner operation. Unit restored to normal heating function.

Completed comprehensive FRM electrical inspection of residential property. Identified deficiencies including outdated electrical panel requiring upgrade to meet current code standards and improperly secured wiring in basement area necessitating re-strapping for safety compliance. Documented existing GFCI outlets in finished and unfinished areas, photographed electrical conditions throughout basement including exposed wiring on wooden framing, and provided detailed estimate for recommended corrective work to address code violations and safety concerns.

Responded to no heat call on residential furnace system. Upon inspection, identified heavily soiled air filter with significant dust accumulation restricting airflow and dirty blower wheel impeding proper operation. Removed and replaced clogged filter, then accessed air handler cabinet to clean blower wheel assembly. System restored to normal heating operation with improved airflow efficiency.

Completed comprehensive electrical inspection of residential property with focus on outlet concerns and overall system evaluation. Documented electrical panel with properly labeled circuit breakers and digital monitoring display, verified all connections secure with organized wiring entering through top conduit. Inspected auxiliary electrical installation including junction boxes, flexible metal conduit, and electronic control board housed in clear protective enclosure mounted on plywood backing. All components found to be properly installed and functioning within code specifications.

Responded to callback for gas leak on recently installed Bradford White water heater. Detected gas leaking from gas valve assembly at vent connection. Replaced defective gas valve under manufacturer warranty, verified proper operation, and confirmed no further leaks detected upon completion.

Completed preventive maintenance agreement service on Lennox air conditioning condenser unit. Performed comprehensive system inspection, cleaned condenser coils, verified fan motor operation, checked electrical connections, and confirmed unit is operating within manufacturer specifications for the upcoming cooling season.

Responded to report of water pooling in laundry room with no known source over the past several weeks. Upon arrival and inspection, identified the existing two-piece water softener system as the source of the water intrusion. Assessed the Superior Water Conditioning unit and associated plumbing connections, including copper piping, gate valves, and flexible hose connections. Provided estimate for replacement of the failing two-piece water softener system with a new Right Impressions water softener unit to resolve the ongoing water leakage issue.

Responded to no-heat call and diagnosed furnace failure to cycle. Upon inspection, determined the inducer motor had failed and was preventing the heating system from operating. Successfully replaced the defective inducer motor with new unit, restoring full furnace operation and heat to the property.