Your Trusted Home Services Team in Rochester, MN

Responded to no cooling call on residential HVAC system less than 10 years old. Located and repaired refrigerant leak in outdoor unit's refrigerant line connections. System tested and confirmed operational upon completion of leak repair.

Responded to callback for persistent whistling noise in Lennox furnace system. Diagnosed failed zone damper causing constant noise issue. Removed defective damper and installed replacement unit, restoring proper zoned heating operation and eliminating noise complaint.

Completed comprehensive preventive maintenance tune-up on residential Goodman air conditioning system. Performed full system inspection, cleaned condenser coils, checked refrigerant levels and electrical connections, verified proper operation of all components, and confirmed unit is operating within manufacturer specifications.

Responded to service call for malfunctioning shower handles in hallway bathroom. Upon inspection, determined the cold water handle was stripped and spinning freely without engaging the valve cartridge. The handle screw was turning the cartridge itself rather than operating the valve mechanism properly. Documented the condition with photographs and advised that repair may require accessing the two-handle valve from the opposite side of the wall, which would necessitate dishwasher removal. Recommended scheduling a follow-up appointment with additional technician support to assess alternative repair options before proceeding with wall access work.

Responded to emergency call for burst pipe causing water intrusion from upper apartment unit into basement area below. Upon inspection, identified kitchen sink drain line leaking at cast iron connection point beneath sink. Attempted initial repair at P-trap and drain connection using standard methods, but leak persisted due to compromised connection integrity. Determined that repair access point needed to be established further downstream along drain line to achieve secure, watertight connection. Due to time constraints and scope of work required, job was rescheduled to allow for proper access and complete repair of drain system.

Responded to callback for insufficient water temperature on recently installed water heater. Upon inspection, found gas control valve thermostat set to "hot" position instead of optimal "A" setting. Adjusted thermostat on gas control valve to "A" setting to provide proper water heating performance.

Responded to callback for repair of outdoor irrigation line that was accidentally punctured near the water shutoff valve. Successfully repaired the damaged pipe section and restored system integrity. All plumbing components, including backflow prevention assembly and pressure regulation system mounted on exterior wall, were inspected and confirmed to be functioning properly upon completion.

Responded to service call for programmable thermostat installation assistance. Upon arrival, determined existing thermostat wire at furnace was insufficient for proper connection of new Honeywell digital programmable thermostat. Ran new thermostat wire from furnace to wall location and completed installation, ensuring proper communication between thermostat and heating system.

Responded to a toilet leak in a residential bathroom. Diagnosed failed wax ring seal at the base of the toilet causing water seepage. Removed toilet from floor flange, replaced deteriorated wax ring with new seal, and properly reset toilet to ensure watertight connection.

Completed one-time AC tune-up on outdoor condensing unit. During system inspection, identified failed capacitor with low microfarad reading. Replaced defective capacitor with new unit to restore proper compressor and fan motor operation, ensuring optimal system performance.

Completed comprehensive electrical inspection of residential property. Identified code compliance issue requiring GFCI protection at washing machine location. Provided estimate for GFCI outlet installation and documented existing conditions with photographs of electrical components and work area.

Completed preventive maintenance on two HVAC systems: one package unit and one split system with furnace and air conditioning. Performed comprehensive tune-up procedures on both units and replaced the package unit filter with customer-supplied filter. All systems operational upon completion.

Responded to emergency call for burst pipe in basement equipment room. Upon arrival, located pin hole leak on copper water line near water heater. Shut off water supply to the home and assessed the damaged section. Cut out the compromised copper pipe and fitting, then installed new copper pipe and fittings to replace the failed section. Restored water service to the home and verified complete system integrity with no additional leaks detected.

Responded to service call for hot tub disconnect installation at residential property. Removed existing weathered spa disconnect box and replaced with new white exterior-rated disconnect enclosure mounted on exterior wall siding. Installation included proper conduit connections, grounding wire continuity, and secure mounting to building exterior. New disconnect provides code-compliant shutoff for spa equipment and integrates with existing electrical service panel visible in basement utility area.

Responded to call regarding leak under sink in basement bathroom. Upon arrival, inspected the lavatory faucet supply lines and identified a loose compression nut on the cold side angle stop valve. Tightened the compression nut to proper specification and tested the system by running water through the fixture. Verified repair was successful with no further leakage detected. Photos documented the completed work.

Completed comprehensive air conditioning tune-up on outdoor condensing unit. Performed full system inspection, cleaned components, verified proper operation of condenser fan and compressor, and confirmed all electrical connections secure. System operating within normal parameters with no deficiencies noted.

Responded to service call for leaking garbage disposal unit. Upon inspection, identified active leak from disposal housing and provided customer with estimate for disposal removal and replacement. Documented existing installation with photos showing disposal unit, mounting assembly, and drain connections for service records.

Returned to property to complete water heater repair by installing cold inlet dip tube on Rheem Classic model unit. Restored water supply to home after installation and verified system operation with no leaks detected and all functions performing properly.

Performed scheduled preventive maintenance on residential Generac 1ekW standby generator unit. Completed comprehensive four-hour service including inspection of all major components, verification of operational readiness, and documentation of equipment condition through photographs showing unit in good working order with no visible damage or deterioration.

Responded to no cooling complaint on Goodman ASX160903 air conditioning unit at mobile home. Upon arrival, confirmed system was running but compressor was not engaging. Diagnostic testing revealed failed dual run capacitor preventing compressor operation. Removed defective capacitor and installed new replacement capacitor with proper microfarad rating. Verified compressor startup, checked amp draw within manufacturer specifications, and confirmed system cooling properly before departure.