Your Trusted Home Services Team in Rochester, MN

Responded to no cooling complaint with system icing up. Upon arrival, found extremely dirty air filter and heavily clogged condenser coil restricting airflow and causing freeze-up conditions. Cleaned condenser coil thoroughly to restore proper heat exchange and system operation.

Responded to service call for malfunctioning shower valve in upstairs hallway bathroom. Upon inspection, found both the shower handle and internal cartridge were stripped and loose, preventing proper hot and cold water control. Assessed that cartridge replacement would be required, though full valve functionality could not be guaranteed due to extent of wear. Customer declined repair as bathroom renovation is scheduled within the month and will utilize alternate bathroom until construction is complete.

Responded to no cooling complaint and discovered R-22 system completely flat with no refrigerant pressure. Due to the age of the equipment, extent of refrigerant loss, and cost considerations associated with R-22, recommended full system replacement rather than repair.

Responded to service call for suspected humidifier leak near furnace. Upon inspection, identified source as cracked evaporator drain pan causing water leakage. Used moisture detection equipment to confirm location and extent of water intrusion. Documented condensation present on supply ductwork and assessed overall HVAC system condition. Discussed findings and repair options with customer, who will schedule preventive maintenance service to address the cracked drain pan issue.

Responded to callback for leaking outdoor faucet that was previously installed. Upon arrival, diagnosed that the packing nut had loosened, causing water to leak when the faucet was turned on. Tightened the packing nut on the hose bib, tested operation, and confirmed leak was eliminated. Also provided estimate for replacement of lift and turn tub drain assembly per customer request.

Responded to callback for air conditioning system not cooling following previous pressure switch replacement. Upon arrival, performed diagnostic inspection of outdoor condensing unit and indoor air handler. System evaluation revealed low refrigerant charge as primary cause of cooling failure. Documented equipment condition with photos showing indoor evaporator coil assembly and outdoor condensing unit. Provided customer with repair estimate for refrigerant recharge and coordinated with project management for approval and scheduling of completion work.

Arrived on-site within scheduled timeframe and contacted customer en route as requested. Conducted comprehensive assessment of existing kitchen plumbing configuration and under-sink area to provide detailed estimate for residential reverse osmosis water filtration system installation. Evaluated available space beneath double-basin sink, existing water supply lines, drain connections, and optimal placement for RO system components including storage tank and faucet mounting location on countertop.

Responded to service call for refrigerant leak on outdoor condensing unit. Upon arrival, diagnosed leak at service valve connection on refrigerant line. Replaced defective service valve with new brass valve assembly, pressure tested system to verify repair integrity, and recharged unit to manufacturer specifications. Unit tested and operating normally upon departure.

Responded to service call for water leaking on floor near furnace from air conditioning system. Upon arrival, confirmed water accumulation on floor in vicinity of indoor air handler unit. Diagnosed clogged condensate drain line as source of water overflow. Cleared blockage by blowing through condensate line to restore proper drainage. Verified system draining correctly and no further water accumulation occurring.

Responded to no cooling complaint and diagnosed system low on refrigerant. Upon inspection, determined the air conditioning system had a significant refrigerant leak that made repair uneconomical. Recommended and completed full system replacement, including outdoor condenser unit and indoor air handler, restoring proper cooling operation to the residence.

Returned to property to complete lavatory faucet installation in bathroom. Successfully installed white porcelain wall-mounted sink with chrome two-handle faucet featuring traditional cross-handle design. Connected all supply lines and drain assembly, including P-trap installation with proper venting to prevent sewer gas infiltration. Verified proper water flow, tested both hot and cold water handles for functionality, and confirmed pop-up drain stopper operation. All plumbing connections secured and leak-tested to ensure system integrity.

Responded to no cooling call and found Lennox S30 smart thermostat with blank screen and evidence of internal burnout, preventing system operation. Removed failed thermostat and installed new Lennox S40 smart thermostat as replacement. Programmed new unit, verified proper communication with HVAC system, and confirmed cooling operation restored.

Completed preventive maintenance tune-up on residential air conditioning system. Performed comprehensive inspection of outdoor condenser unit, verified all components operating within normal parameters, and system tuned to manufacturer specifications with no deficiencies identified.

Responded to service call for basement laundry tub installation. Upon arrival, coordinated with flooring contractor to ensure work area was accessible. Successfully connected existing white plastic utility sink with chrome faucet to the plumbing system, establishing proper water supply and drainage to function in conjunction with the washing machine. Verified all connections were secure, tested hot and cold water flow, and confirmed drain operation. Installation completed and system operational.

Responded to service call for coil installation on residential HVAC system. Successfully installed replacement evaporator coil and restored system to full operational status, with unit now cooling properly.

Completed comprehensive preventative maintenance tune-up on residential Lennox air conditioning system. Performed full system inspection, cleaned condenser coils, verified refrigerant charge, tested electrical components, and confirmed optimal operation with no deficiencies found.

Responded to no cooling complaint and diagnosed faulty thermostat. Removed defective unit and installed homeowner's existing PRO1 digital programmable thermostat per customer request. Verified system operation with thermostat properly controlling cooling cycle to setpoint of 72°F.

Responded to service call for bidet outlet installation. Upon arrival, assessed electrical requirements and reviewed scope of work with homeowner. After discussing project details and clarifying that electrical work was separate from plumbing installation, homeowner declined to proceed with the outlet addition at this time.

Responded to no cooling call on system with zone control. Upon arrival, diagnosed communication failure between air conditioning unit and zone control board. Zone control panel mounted on basement wall showed no communication with HVAC system, preventing proper operation. Ordered replacement zone control module to restore system functionality.

Responded to service call for air conditioning system that would not stop running at set temperature and was producing loud noise. Diagnosed failed zone damper causing system malfunction. Removed defective zone damper from attic-mounted HVAC system and installed new replacement damper. Tested system operation to verify proper cycling and temperature control. Identified additional zone damper showing signs of wear and provided estimate for replacement to prevent future issues.