Rochester Area

507-282-4328

Twin Cities Area

952-204-5299

24/7 Emergency Service

Rochester Area

Twin Cities Area

Furnace repair is needed anytime you start noticing an issue, even if it is minor. One way to notice this is different temperatures in the home. Is your heating system blowing cold to moderate air and not warm air? Does one room seem chiller than the other? Is your HVAC system not distributing air evenly? If that is the case, the information discussed in this piece can help your HVAC system get back to producing air properly.

Furnace Repair and the Thermostat

When you check your thermostat setting with the heater on, make sure that the thermostat is set on heat. If you have a programmable thermostat, then make sure to replace its battery in a timely manner to make sure that it is working correctly.

You should also make sure that you have set your thermostat at least ten degrees warmer than the current indoor temperature. This will give a better idea of your heating system, and give you clear insights over its heating capacity.

Test Thermostat Accuracy

Like all electronic items, thermostats are also subject to degradation with time. Thus, if you have been using the same thermostat for a long time, it is best not to trust that thermostat’s accuracy until you have not measured it. To test your thermostats accuracy, it is best that you use a temperature gauge. First, measure the internal temperature using the gauge. After that, turn on the heater system inside the house and wait for a couple of minutes to ensure that the hot air takes effect.

After that, take the measurement again and compare the two readings. If they do not match, then this indicates that your thermostat may be out of calibration. To solve this problem, you will have to reset the thermostat. Resetting the thermostat is important, as it refreshes the thermostat system. Another option would be to replace the thermostat with a new one.

Check Power Unit

Sometimes your HVAC system is not functioning due to a circuit breaker trip. In that case, flip the switch of the breaker. This should not happen often, and it you notice it happening frequently, it is best to consult a licensed HVAC technician. Furthermore, another fix to this problem is that you should check the master switches to the furnace system. Make sure that it is receiving adequate electricity.

Furnace Repair

Your furnace issues can be solved simply by looking and finding an air filter. The accumulation of dirt, debris and other particles inside the air filters can restrict the airflow and impact the temperature of your home. Therefore, it is very important to change your air filters every other month or when they have become dirty.

Minor steps such as the ones mentioned above can go a long way when it comes to your HVAC systems longevity. Following these steps this fall may not only improve your furnace output, but also help you save hefty costs of hiring technicians